Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multicast - RP questions

Hi,

Recently I enabled a multicast group to connect to a different rp-address. Following that all subscriber traffic was via the new rp. However, I had a problem and as a result I had to disable this new rp setup. I removed the rp configuration from the switch i.e "no ip pim rp-address 10.20.3.2 WAN-GROUPS". After this I looked at the output from "show ip mroute" and I saw the traffic was still being sent via the new rp.

Can someone explain this, do I need to reload or clear some table?

Thanks

Dan

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Multicast - RP questions

Hi Dan.

The multicast streams will stay in place until they age out, although it will not make much of a difference as with default settings the multicast tree will change to source based anyway.

If you need to see a difference try 'clear ip mroute *'

(or you can use the same command but specify the particular groups)

Simon

1 REPLY

Re: Multicast - RP questions

Hi Dan.

The multicast streams will stay in place until they age out, although it will not make much of a difference as with default settings the multicast tree will change to source based anyway.

If you need to see a difference try 'clear ip mroute *'

(or you can use the same command but specify the particular groups)

Simon

274
Views
0
Helpful
1
Replies