05-08-2012 07:43 AM - edited 03-07-2019 06:35 AM
I have configured multicast(ip pim dense-mode) on two 2911 that are connected by a Multilink( 3 Mbps) Wan connection.
The configuration works fine for awhile and sometimes all day but at some point one of the Multilink interfaces stops passing multicast traffic.
I perform a SH Multilink 1 on the interfaces and one show multicast packets incrementing and one does not, it just stops.
The problem acts like there is a buffer that gets full and after that happens it just stops working.
Has anyone heard of this or seen this issue before?
Thanks,
Desmond
05-08-2012 12:29 PM
hi Desmond,
You're posting on the Cisco Spanish Community,(Comunidad de Soporte de Cisco en Español )
I suggest to post your question on the right community, in addition include IOS version of your network devices as we might need to desregard any possible bug or known behavior, I wish I had more ideas but it is been a while since I had to deal with multicast issues.
I hope you get your question address soon,
saludos!
Felix A
WAAS-TAC Support
05-08-2012 01:05 PM
Thank you that was a mistake.
Thanks for letting me know!
Desmond
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide