I am trying to get Multicast packets to cross VLANs on a 3560 switch. I have IP phones off VLAN 2 and the rest of the network on vlan 1. Port 1 is only in vlan 1 and the rest are trunk ports in both vlan 1 and 2. Phones are Vlan 2. I have routing turned on.
Attached is my router config and a debug of the multicast group. I did a monitor of both of the ports (fa 0/1 (router port) and fa 0/19 (phone port) and port fa 0/1 is seeing the multicast traffic but does not show up on port 0/19.
Neither the ip multicast-routing for the switch nor pim sparse-mode for the vlan interface is available for this IOS. I looked to see if could go to 12.3 or 12.4 but there is no version of IOS for this switch.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.