Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Multicast

Hi

Dear Netpro!

in multicast when we configure ip sparse-mode,then no need configure the Command:

no ip pim dm-fallback & ip pim send-rp-announce int scope 16,is this Correct?

did we just need this command instead:ip pim rp-addrerss z.z.z.z?

many 10xs

1 REPLY
Hall of Fame Super Blue

Re: Multicast

Ali

It depends on whether you want to use Auto-RP or not.

If you don't and you just want to statically configure the RP address on all multicast routers then yes you are correct you do not need the "ip pim send-rp-announce int scope 16" command.

As for "no ip pim dm-fallback" this stops the router falling back to dense mode if there is no RP for a group. So if your RP that you statically configure is responsible for all groups you'll be fine.

Jon

105
Views
0
Helpful
1
Replies