Multicasting between cisco 3560 and cisco 2950 switch
for multicast traffic testing i have cisco 3560 switch and cisco 2950 switch. if i create multiple VLANs on cisco 3560 switch and if i am doing testing multicast traffic by keeping multicast server in one vlan and test machine in other vlan it works well.howerver if i connect test machine to 2950 switch , testing does not work.
i have created same vlans on both the switches
what will be the minimum configuration required to set up multicast traffic between these two switches.
Re: Multicasting between cisco 3560 and cisco 2950 switch
im not really sure why it works on the 3560 as it shouldn't. the only way for multicast to reach from one vlan to another would be to route, just like normal traffic. Therefore, you would have to turn on multicast routing, create a routing interface on each vlan and enable pim for it to work.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...