Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Multilink

i have two 4506 series switches, and want to config multilink over giga port. Pls let me know the basic config for same

Thanks

abl

3 REPLIES

Re: Multilink

Here is the config:

interface Multilink1

description *****MULTILINK in Mumbai*****

ip address x.x.x.x

ppp multilink

ppp multilink group 1

!

!

interface Serial0/3/0

description **CIR 1**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Serial0/3/1

description **CIR 2**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Multilink1

description *****MULTILINK in Chennai*****

ip address x.x.x.x

ppp multilink

ppp multilink group 1

!

!

interface Serial0/3/0

description **CIR 1**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

!

interface Serial0/3/1

description **CIR 2**

bandwidth 2048

ip address x.x.x.x

encapsulation ppp

ppp multilink

ppp multilink group 1

hope that clarifies.

Pls rate all helpful posts.

Re: Multilink

OOpppsssssss.sorry.

Cisco Employee

Re: Multilink

Hi,

Multilink configuraation is not supported on Gigabit interface. You can try port aggregation (Etherchannel).

Below mentioned URL will help you to understand and configure Etherchannel.

http://cisco.com/en/US/docs/switches/lan/catalyst4000/7.4/configuration/guide/channel.html#wp1032149

HTH,

Nagendra

108
Views
0
Helpful
3
Replies
CreatePlease to create content