In the following example you can find the configuration about the interface with the vlan. Here there is a bond interface, but is the same if you use eth :
auto bond0 iface bond0 inet static address 172.16.0.6 netmask 255.255.255.128 network 172.16.0.0 up /sbin/ifenslave bond0 eth0 eth2 eth3 up vconfig add bond0 2 up /sbin/ifconfig bond0 0.0.0.0 up ip addr add 172.16.0.6/25 brd 172.16.0.127 dev bond0.2 up ip link set bond0.2 up up vconfig add bond0 4 up ip addr add 172.16.0.130/25 brd 172.16.0.255 dev bond0.4 up ip link set bond0.4 up
auto bond1 iface bond1 inet static address 192.168.0.2 netmask 255.255.252.0 network 192.168.0.0 up /sbin/ifenslave bond1 eth1 eth4 eth5 up vconfig add bond1 90 up ip addr add 192.168.90.2/24 brd 192.168.90.255 dev bond1.90 up ip link set bond1.90 up up vconfig add bond1 91 up ip addr add 192.168.91.2/24 brd 192.168.91.255 dev bond1.91 up ip link set bond1.91 up
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...