It would help us to give better answers if we knew a bit more about your environment. But in general it is possible to configure a port on the switch as a trunk and to carry multiple VLANs over the trunk. Then you would configure the router interface to participate in the trunk, and would configure subinterfaces on the router interface, one subinterface per VLAN, and the IP address on the subinterface would be the gateway for the VLAN.
It might also be possible to configure multiple addresses on the router interface without using trunking by configuring a primary IP address and then a series of secondary addresses on the router interface.
You really want to avoid using 'ip address secondary' if possible. Make the interface into a trunk, then make your virtual subinterfaces such as fa0.1 fa0.2 fa0.3 etc and assign them an IP address. I'll post some example code in a second.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.