Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Multiple mac address addition and deletion on 3524XL switch

Hi,

I am having a 3524XL switch and I am getting the below error message.

Add address 0004.4d95.9a80, on port 27 vlan 100

I am getting the error message with different address for both addition and deletion and different vlan for same port 27.

Could you please confirm why error is seen on port "27" on a 24 port switch.?

Also what exactly the error corresponds to.

Please provide any good link for the issue.

Thank you,

Peter

3 REPLIES
Cisco Employee

Re: Multiple mac address addition and deletion on 3524XL switch

Port 27 is logical port number used by STP. 'show spanning-tree' command should show whichphysical port matches with the logical ports your seeing. (ie: Fa0/1 is

port 13)

3500#sh spanning-tree

Interface Fa0/1 (port 13) in Spanning tree 1 is down

Interface Fa0/2 (port 14) in Spanning tree 1 is down

I suspect a layer 2 loop or misconfig causing these errors. Following tech tip should help

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094afd.shtml#t4

New Member

Re: Multiple mac address addition and deletion on 3524XL switch

Hi,

Thanks for the reply. But if it is a spanning-tree loop the same mac-address should be learned through another port or interface .here I am not getting same mac address in other ports. So please help to identify the exact issue.

Thank you

Peter

New Member

Re: Multiple mac address addition and deletion on 3524XL switch

Hi,

Without enabling any debugs we are getting the add and deletion messages.

If we enable udld, will it help.?

Thank you,

Peter

133
Views
0
Helpful
3
Replies
CreatePlease to create content