Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Multiple SPAN destination ports for a single source port?

Is it possible to have multiple local destination SPAN ports for a single local source SPAN port on a 2960G switch running IOS 12.2(25)SEE3? and if not - does anyone know a workaround? Thanks.

1 REPLY
Cisco Employee

Re: Multiple SPAN destination ports for a single source port?

Hi Friend,

Yes you can have multiple destination span port for a single source span port. But it can participate in only one SPAN session at a time (a destination port in one SPAN session cannot be a destination port for a second SPAN session).

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2960/12240se/scg/swspan.htm#wp1251490

You can use the following command

monitor session 1 source interface gig0/10

monitor session 1 destination interface Gi0/1 - 2

HTH

Ankur

*Pls rate all helpfull post

348
Views
0
Helpful
1
Replies
CreatePlease to create content