Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

My 6500 router always start in romoon

Hello,

I have a problem that have been an issu for a very long time and I cant get it solve.

So I hope there is anyone here that can help me.

When my router restarts, power failure, when I type "reload" or other things who make it reboot itself. It always stop in "rommon>" and Its very annoying.

 

This Is how my config is:

=====================================================================================

6500-FK01#show boot
BOOT variable = disk0:s72033-advipservicesk9_wan-mz.122-33.SXI5.bin,1;disk0:,12;sup-bootflash:,12
CONFIG_FILE variable =
BOOTLDR variable = bootflash:s72033-boot-mz.122-33.SXI3.bin
Configuration register is 0x2102

Standby is not up.

=====================================================================================

6500-FK01#dir disk0:
Directory of disk0:/

    1  -rw-   116737380   Jan 1 2000 03:17:08 +01:00  s72033-advipservicesk9_wan-mz.122-33.SXI5.bin

127918080 bytes total (11177984 bytes free)

=====================================================================================

 

How can I make my router to boot up automaticly?

 

Many thanks! Emil

 

6 REPLIES
Hall of Fame Super Gold

Your boot variable string is

Your boot variable string is incorrect.  

 

To correct this, you need to do this: 

config t
no [ENTER INCORRECT BOOT VARIABLE STRING HERE]
boot system flash disk0:s72033-advipservicesk9_wan-mz.122-33.SXI5.bin
end
wr
New Member

Thanks for the tip! Now Its

Thanks for the tip!

 

Now Its looks like this!

 

show run

======================================

hostname 6500-FK01
!
boot system flash disk0:s72033-advipservicesk9_wan-mz.122-33.SXI5.bin
enable password 7 065043355E4F11
!

======================================

show boot

======================================

6500-FK01#show boot
BOOT variable = disk0:s72033-advipservicesk9_wan-mz.122-33.SXI5.bin,1
CONFIG_FILE variable =
BOOTLDR variable = bootflash:s72033-boot-mz.122-33.SXI3.bin
Configuration register is 0x2102

Standby is not up.

 

======================================

 

I cant test this right away because this router are in production right now.

Is this correct? :)

 

Many thanks.

Hall of Fame Super Gold

That should be correct, Emil.

That should be correct, Emil.

New Member

Thank you Leo Laohoo! =)This

Thank you Leo Laohoo! =)

This will be intressting that day we need to reboot again.

What does "remote command

What does "remote command switch show version | include register" output?

Cisco Employee

check for "remote command

check for "remote command switch show version"

and look for config register value to be 0x2102------>if it is different change it to 0x2102

r1>conf t

r1-conf> config-register 0x2102

r1>write mem

and than reload

Regards,

Naveen 

****rate if it is helpful****

 

86
Views
0
Helpful
6
Replies