N5K Interface unable to connect to port-channel - command fail
Removed the configuration for Po101
Configured all applicable ports which will participate with Po101
Re-Configured Po101 with the original config.
switchport mode fabricpath
lacp min-links 2
switchport trunk native vlan 999
fabricpath isis metric 5
Everything is working.
I always thought you could configure additional ports without modifying the actual port channel. That is not the case. The Port Channel must be configured last. Adding additional interfaces after the Po has been created didn't work.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.