I tried to use a 1G SFP on the N7710 F3 module. But kept getting "Transceiver speed does not match the speed configured on the port" message.
Is there any tricks on that? e.g. do I have to configure the port speed / plug in the SPF in specific order? Thanks!
interface Ethernet1/42 speed 1000
Ethernet1/42 is down (Transceiver speed does not match the speed configured on the port) admin state is down, Dedicated Interface Hardware: 1000/10000 Ethernet, address: 002a.6a8c.9541 (bia 544a.00ad.59a5)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.