I have two data centers with 2 N7K per DC. There is a vPC peer link between the two units in the same DC. N7K A at data center A connects to N7K A at data center B & N7K B at data center A connects to N7K B at data center B over a 2 WAN links. Can I load balance over equal cost links with EIGRP or will the vPC peer links be seen as a hop and thus there will not be equal cost links?
I am still in the planning stage and it looks like OTV is not an option.
Re: N7K EIGRP load balancing between to data centers
The vPC peer-link is L2, and it should not consider a L3 hop. For vPC VLANs/devices between both DC, yes, EIGRP can be used to load shared traffic (assuming you are doing L3 between DC since you are running EIGRP). If you have one-arm servers (or active/standby NIC), no, traffic will not be load shared.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...