Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

N7K M1 Interfaces stuck in initializing state

It's a weired issue in N7010, checking is anyone here came across the same?

We did an upgrade from NX-OS 5.1.5 to 5.2.4 and found all M1 line card interfaces were stuck in initializing state for long time.'show module' status says ok. And we cannot execute shut/no shut command under the interface.  N7K-M108X2-12L & N7K-M148GT-11 are the two M series cards. Only option was to downgrade back for the time being. Anyone had the same issue and got resolved?

N7K01# sh int e1/1 | in down

Ethernet1/1 is down (initializing)

Regards,

Everyone's tags (6)
3 REPLIES
Hall of Fame Super Gold

N7K M1 Interfaces stuck in initializing state

I've checked the 5.2 Release Notes and I don't see anything mentioned like what you've experienced.

Can you try running the newer 6.0?

New Member

N7K M1 Interfaces stuck in initializing state

Already 4 chassis are working fine with the new image and the issue is encountered only in this. The box is in production now. ;(

Hall of Fame Super Gold

N7K M1 Interfaces stuck in initializing state

Ok then.  Try reseating the card. 

488
Views
2
Helpful
3
Replies
CreatePlease login to create content