cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
941
Views
2
Helpful
3
Replies

N7K M1 Interfaces stuck in initializing state

kokulsharma
Level 1
Level 1

It's a weired issue in N7010, checking is anyone here came across the same?

We did an upgrade from NX-OS 5.1.5 to 5.2.4 and found all M1 line card interfaces were stuck in initializing state for long time.'show module' status says ok. And we cannot execute shut/no shut command under the interface.  N7K-M108X2-12L & N7K-M148GT-11 are the two M series cards. Only option was to downgrade back for the time being. Anyone had the same issue and got resolved?

N7K01# sh int e1/1 | in down

Ethernet1/1 is down (initializing)

Regards,

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame

I've checked the 5.2 Release Notes and I don't see anything mentioned like what you've experienced.

Can you try running the newer 6.0?

Already 4 chassis are working fine with the new image and the issue is encountered only in this. The box is in production now. ;(

Ok then.  Try reseating the card. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco