Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

N7K - powered-dn module status

Hi guys,

 

Suddenly, one of the modules under 7K switch gave red alarm.

 

Following are the show module:

#show module
Mod  Ports  Module-Type                         Model              Status
---  -----  ----------------------------------- ------------------ ----------

4    0      10 Gbps Ethernet Module                                powered-dn

Mod  Power-Status  Reason
---  ------------  ---------------------------
4    powered-dn     Unable to power up card (Power_OK not set)

Mod  Sw              Hw
---  --------------  ------
1    6.2(6)          3.0     
3    6.2(6)          1.0    

 

Any common issue for that?

Regards.

3 REPLIES
Silver

Hi, Please try this. 1. Set

Hi,

 

Please try this.

 

1. Set on config t the diagnostic bootup level complete

2. Reseat module 4

3. show diagnostic result module 4

4. show module

If you still face the same issue after reseating it then RMA the module. Also check the available power on the switch and the minimum version required for the module to run fine.

New Member

Hi, There is no "Reseat

Hi,

 

There is no "Reseat module 4" command.

 

Regards

Purple

  He means to pull the card

  He means to pull the card out and then reseat it into the backplane..

64
Views
0
Helpful
3
Replies
CreatePlease login to create content