Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAM module

Is't possible to install NAM module into Cat650x/760x without shutdown device?

2 REPLIES
Hall of Fame Super Blue

Re: NAM module

Mike

Yes, the 6500 switch supports OIR (Online Insertion & Removal) for all of it's modules which includes the NAM.

Before you do insert it best to check that your are running version of software that supports it. If not it won't bring the switch down just the NAM module will not come up properly.

Jon

Re: NAM module

Hi,

All the Catalyst 6500 series and Catalyst 6000 family switches support hot swapping, which allows you to install, remove, replace, and rearrange modules without turning off the system power.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Config_Notes/78_14487_support_TSD_Island_of_Content_Chapter.html#wp79713

All Catalyst 6500 series switches, Catalyst 6000 series switches, and Cisco 7600 series routers support hot swapping, which allows you to install, remove, replace, and rearrange modules without turning off the system power.

http://www-europe.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/nam/nam_3_4/hw_gd/78_16855.htm#wp36309

I would suggest to wait for more exprets comments on this.

regards,

Pravin..

228
Views
10
Helpful
2
Replies