I have an internal network 192.168.10.0/24 on Ethernet0, DSL (Dialer1 interface) is dynamically assigned by ISP, Loopback0 has a static public IP address 126.96.36.199. Traffic originating from outside (Dialer1) is NAT'd from 188.8.131.52 to 192.168.10.34, but when a VPN client connects via PPTP, they are assigned an address of 192.168.11.2 and cannot reach 184.108.40.206 because of NAT issues.
QUESTION: How can I NAT 220.127.116.11->192.168.10.34 for traffic that comes over PPTP VPN?
Note that both the Eth0 and Virtual-Template2 interfaces are "ip nat inside" because PPTP traffic is routed back out to the internet if the destination is not a local network (192.168.10.* or 192.168.11.*)
no access-list 101
! except VPN Client traffic from NAT process
access-list 101 deny ip 192.168.10.0 0.0.0.255 192.168.11.0 0.0.0.255
access-list 101 deny ip 192.168.11.0 0.0.0.255 192.168.10.0 0.0.0.255
access-list 101 permit ip 192.168.10.0 0.0.0.255 any
access-list 101 permit ip 192.168.11.0 0.0.0.255 any
ip nat inside source list 101 interface Loopback0 overload
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.