03-09-2014 12:25 AM - edited 03-07-2019 06:36 PM
I am in the process of configuring a router and while deploying some of the NAT translations I ran into a problem.
router(config)#ip nat inside source static tcp 10.0.20.105 22 interface gigabitEthernet 1/1 23
%Port 23 is being used by system
router(config)#do clear ip nat trans forced
router(config)#ip nat inside source static tcp 10.0.20.105 22 interface gigabitEthernet 1/1 23
%Port 23 is being used by system
Telnet is not enabled, and clearing the nat translations did not fix the problem. Anyone have any ideas?
Thanks!
03-10-2014 05:37 PM
Bump.... this was opened during Cisco's maintenance window.
05-16-2014 12:24 PM
Hi,
I have the same issue on 6504-E with IOS version s72033-adventerprisek9-mz.151-2.SY2.bin.
you fixed the problem?
Thanks,
Sergio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: