Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Nat Misses and Nat slowness

Currently we have a dynamic nat rule and three static nat rules. Whenever the static routes are enabled, Lan users experience long route seek times, takes a long time for a page to actually start loading. Using show ip nat statistics, Hits:4644285 Misses: 70410. Are these misses related to this problem? If not is there a recommended fix to the problem? Thanks in advanced

5 REPLIES

Re: Nat Misses and Nat slowness

can u pls paste the NAT config ?

New Member

Re: Nat Misses and Nat slowness

interface Vlan1

description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$ES_LAN$$FW_INSIDE$

ip address 192.168.123.1 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip nat inside

ip virtual-reassembly

ip route-cache flow

ip tcp adjust-mss 1452

ip http server

ip http authentication local

ip http secure-server

ip http timeout-policy idle 60 life 86400 requests 10000

ip nat inside source list 1 interface FastEthernet4 overload

ip nat inside source static tcp 192.168.123.50 22 interface FastEthernet4 22

!

New Member

Re: Nat Misses and Nat slowness

Standard IP access list 1

10 permit 192.168.123.0, wildcard bits 0.0.0.255 (253 matches)

New Member

Re: Nat Misses and Nat slowness

I found something interesting today. The cisco router is using the interface FastEthernet3 which has no cable attached into it. We only have FastEthernet4 attached with a cable to the Lan. I searched throughout all of the cisco's config files and interface FastEthernet3 does not show up as an interface for traffic. Is this normal?

New Member

Re: Nat Misses and Nat slowness

I am haing the same problem too. If anyone finds a solution, please let me know.

367
Views
0
Helpful
5
Replies