Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

NAT on 4510R

A colleague has asked me what SW supports NAT on the 4510R (SUP5), and the SW advisor is currently not listing ANY features at all! He has apparently tried to configure it, and it does not recognise the command.

I would have expected NAT support to be pretty widespread - can anyone confirm what feature sets should support NAT.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: NAT on 4510R

Paul,

NAT is not supported on the 4500 Switches. Please refer the below URL that lists the Network Address Translation Catalyst Switch Support Matrix

http://www.cisco.com/warp/public/473/166.html#topic1

Also, if you want to do large number of NAT, then also look at Firewall Services Module in the Catalyst 6500.

I hope it helps.

Regards,

Arul

4 REPLIES
Hall of Fame Super Blue

Re: NAT on 4510R

Hi Paul

As far as i know the 6500 is the only switch that supports NAT. Yes i know it is a bit of pain. So if you want to do NAT you need to purchase either a 6500 or install a router in the path.

Neither solution is great !

Jon

Re: NAT on 4510R

Thanks Jon - bit of an omission in function there!

Paul.

Cisco Employee

Re: NAT on 4510R

Paul,

NAT is not supported on the 4500 Switches. Please refer the below URL that lists the Network Address Translation Catalyst Switch Support Matrix

http://www.cisco.com/warp/public/473/166.html#topic1

Also, if you want to do large number of NAT, then also look at Firewall Services Module in the Catalyst 6500.

I hope it helps.

Regards,

Arul

Re: NAT on 4510R

Thanks for the response - the link is just what I needed.

Paul.

306
Views
9
Helpful
4
Replies