We have a fully meshed OSPF network using 6500 switches at the Core and Dist Level. Off two of the Dist Switches are external routers that route out to other networks. All traffic going to the external networks goes through these two 6500 switches.
We need to NAT traffic from specific private subnets going through these switches out to external networks.
I think we got it to work using static NATs but would prefer to use a NAT pool and overload.
I'm told they cannot do stateful NAT between two redundant switches
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...