Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

NAT on a C7600 with SUP720/PFC3BXL

Hello,

i have a C7600 with SUP720/PFC3BXL running 122-33 SRB2 (advanced enterpr.). It is necessary to configure NAT between 2 interfaces belonging to the same VRF. It works fine for TCP traffic but not for UDP traffic. There is a CAVEAT for UDP traffic and NAT on the SUP720/PFC3A (IOS 12.2SXF) that looks like the behavior i am observing in the above described situation. Does anyone about some similar limitation for the HW/SW i am using. I didn't find any reference so far in the docs.

Thanks in advance

1 REPLY

Re: NAT on a C7600 with SUP720/PFC3BXL

UDP NAT issue should be fixed in PFC3B and PFC3BXL. But you are trying to use "VRF aware NAT" here, I am not sure if it can be done. As far as I know, you might need to use FWSM.

151
Views
0
Helpful
1
Replies
CreatePlease to create content