I have a WS-C4948 Enterprise Services Switch that I would like to run NAT Overloading between 2 VLAN's. However, I tried assigning the inside and outside interfaces using the "ip nat outside" and "ip nat inside" commands. I have tried these under routed interfaces and vlan SVI's (i.e. Interface vlan1) and none would accept the nat configuration.
Is there a way to setup nat on a 4948 Switch with the enterprise feature set license? I only need this for outbound nat to translate several private IP's to a single public IP when connecting to the internet.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...