You don't need subinterfaces because the ISP will route those new IPs to your router anyway so the addresses don't neeed to be assigned to an interface. So lets say the 10.3.1.0/24 dept needs it's own IP -
new public IP to be used 188.8.131.52
remove 10.3.1.0 from the existing NAT acl
access-list 101 permit ip 10.3.1.0 0.0.0.255 any (note you can use a named acl if you want)
ip nat pool <-- you may want something meaningful to the dept here> 184.108.40.206 220.127.116.11 netmask 255.255.255.252
ip nat inside source list 101 pool overload
That should do it. Bear in mind when you add this config you will need to clear any existing NAT translations for the 10.3.1.x network.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.