Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT pool and overloading

Hello

I have such configuration:

Router(config)# ip nat pool net-208 209.165.202.1 209.165.202.15 netmask 255.255.255.240

Router(config)# access-list 1 permit 192.168.1.0 0.0.0.255

Router(config)# ip nat inside source list 1 pool net-208 overload

Router(config)# interface ethernet 1

Router(config)# ip nat inside

Router(config)# interface ethernet 0

Router(config)# ip nat outside

I have 15 outside addresses and i use overload. How will these addresses be allocated for my internal users ? Will they all be used in round robin fashion ?

For example if all of my interlan users (254) browse www server will all outside addresses be used and will have similar number of translations ?

Thanx

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: NAT pool and overloading

My understanding is that the first 14 users will use a unique IP from the 209.165.202.1 -> 14 range and then all other clients will be overloaded on the last available address.

Jon

1 REPLY
Hall of Fame Super Blue

Re: NAT pool and overloading

My understanding is that the first 14 users will use a unique IP from the 209.165.202.1 -> 14 range and then all other clients will be overloaded on the last available address.

Jon

121
Views
0
Helpful
1
Replies