Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT port forwarding

I have recently purchased a Cisco 871 router. In the GUI from the installed software, I have been able to configure which ports are forwarded to a specified IP address within my local area network.

This seems to output a configuration line like this:

ip nat inside source static tcp 192.168.1.123 1000 interface Dialer0 1000

However, I can only do this one port at a time. Is there a function or command that I can use to specify a range of ports? For example, I would like to forward tcp ports 1000-2300 to the IP address 192.168.1.123.

Any help would be appreciated.

1 REPLY
Silver

Re: NAT port forwarding

I think in order to support the use of non-standard FTP port numbers, you must use the ip nat service command. This is a sample syntax: router-6(config)#ip nat service list 10 ftp tcp port 2021.

For more information please click following URL:

http://www.cisco.com/en/US/docs/net_mgmt/signaling_gateway_manager/2.2/user/guide/sgmunetw.html#wp1031911

117
Views
0
Helpful
1
Replies