Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT runing on more then one interface?

I?m looking for a way to use NAT on 2 or more interfaces on my router. I

have studied this a little bit and attempted to create a second NAT statement but every time I tried the previous interface that already has NAT applied looses it connection. I would hate to buy a dedicated router for every connection.

A better way to explain it is that 192.168.1.1 is my internal LANs interface. Lets just say 10.1.0.1 is a interface and 10.2.0.1 is another interface going to other LANs. I want all traffic coming from my internal interface (192.168.1.1) to show up as 10.1.0.1 when it goes out that interface or shows up as 10.2.0.1 if it is routed out that interface. I guess basically I need two outside interfaces. Is this possible?

Thank you

1 REPLY

Re: NAT runing on more then one interface?

107
Views
4
Helpful
1
Replies