I have R4 connected to R1 over a point to point serial link (Outside). IP addressing is 172.16.1.0/29 - .1 is on R1 and .2 is on R4. R4 has a loopback 220.127.116.11 (Inside). R1 is on a LAN with R2 and R3. The network is 192.168.1.0/24 .1 on R1, .2 on R2 and .3 on R3. There is full reachability from anywhere to anywhere.
What I want is this.
1. R4 should never NAT if 18.104.22.168 pings R3 and vice versa.
2. R4 should always NAT if 22.214.171.124 pings R2 and vice versa. The NAT address should be 172.16.1.3 (outside) always.
3. R2 should always be able to reach 126.96.36.199 by pinging 172.16.1.3
Configuring a static entry solves issues 2 and 3 but breaks issue 1.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...