Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

NAT support in switches

Hi,

Which L3 switches are supporting NAT feature. I think above 4500 switches supports this NAT feature.

Regards,

Guru

1 ACCEPTED SOLUTION

Accepted Solutions

Re: NAT support in switches

Just the 6500's with Sup2/MSFC2 or later. I wouldn't recommend it for anything other than the odd host though as it's handled in software.

Andy

2 REPLIES

Re: NAT support in switches

Just the 6500's with Sup2/MSFC2 or later. I wouldn't recommend it for anything other than the odd host though as it's handled in software.

Andy

Re: NAT support in switches

There is actually a caveat with the 4500s supporting NAT

Catalyst 4500/4000 series switches with Supervisor Engine III/IV support the Access Gateway Module (AGM) in Cisco IOS Software Release 12.1(13)EW or later. You need Cisco IOS Software Release 12.2.13T or later on the AGM module. NAT has support in the software switching path on the AGM module.

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a008011c629.shtml#topic1

168
Views
0
Helpful
2
Replies
CreatePlease to create content