Static NAT's basically get translated through the layer 3 routing path. In any case if you want to specifically map traffic based on the source IP addresses, you can use a route-map with a static NAT. route-map will have an access-list associated with it, which informs the source and destination subnets for outside NAT to happen.
ip nat inside source static 188.8.131.52 184.108.40.206 route-map outbound1
route-map outbound1 permit 10
match ip address 100
set ip next-hop x.x.x.x
access-list 100 permit ip 192.168.10.0 0.0.0.255 10.1.0.0 0.0.0.255
In this case only traffic destinted through 10.1.0.0 (say through vlan 700) is natted. Any other traffic through vlan 652 is not natted. YOu can refer to the following URL for more info:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.