If i understand correctly you just want to NAT both the 10.1.1.0 & the 10.2.2.0 networks as they pass through the router.
Yes this is fine and there should be no problem unless i have misunderstood your topology. The router always keeps a record of the source IP address and port so it will know whether the packet is from 10.1.1.x or 10.2.2.x.
this can work althought the first network pass throught the second? i thought that the packets comes from the first network encapsulated with new frame from the second and it would be impposible to be recognized the ititial ip source....
its a fiber optical which connect to lans using sw3550 and after these switches its the router where i want to put the nat and drime me to the internet. the routed interfaces are the Gi interfaces from 3550 switches .
I was thinking that tha packets comes from the network 10.1.1.0 directed throught the 10.2.2.0 at the router changed the ip source addresses from the routing proccess and so the nat would recognize only one network and not the two .
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...