cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
439
Views
8
Helpful
5
Replies

Nat

alsayed
Level 1
Level 1

HI

I Have 2 servers(web-server & exchange server) with fake ip on my lan(10.10.10.10 & 10.10.10.11) as well a 2621 series router.i want to nat this 2 server to the public ip address(194.x.x.20)what could be the the config in my router as a NAT Config?

10xs for ur help

5 Replies 5

network.king
Level 4
Level 4

Hi ,

You can do a pat for the required private ips . Only your servers can contact outside using pat . If from outside , if you want to reach the servers , you need to do a one to one nat .

pls find the config based on your requirement

access-list 10 permit host 10.10.10.10

access-list 10 permit host 10.10.10.11

interface lo10

ip address 194.126.20.20 255.255.255.255

ip nat outside

int fa0 --- private lan

ip address 10.10.10.1 255.255.255.0

ip nat inside

ip nat inside source list 10 interface loopback10 overload

Also do a "ip nat outside " on your wan interface .

hope it helps

regards

vanesh k

hi vanesh;10xs for ur reply

You can use SDM for GUI based creation of NAT on Cisco router. Ofcourse if only your Cisco router supports then only. SDM is cool. Everything u can do via GUI based interface. Even u can monitor activities of all interfaces i.e. Serial, Ethernet and blah blah blah.

Regard's,

Amey Abhyankar.

Hi

plz;can u list some USEFUL link about SDM;u found it very usefull

10XS

Hi ,

Cisco Router and Security Device Manager Quick Start Guide link is below.

http://www.cisco.com/univercd/cc/td/doc/product/software/sdm/sdmqsg/sdmq21.htm

Thanks,

satish

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: