Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NAT

I have following topology

----Fa0/0-Router----S0/0/0

Fa0/1

|

|

|

Fa0/0 is running IP NAT INSIDE and S0/0/0 in running IP NAT OUTSIDE. I am doing typical IP NAT INSIDE translation and its working fine. How do I exclude traffic that I need to be normally routes over Fa0/1 coming from S0/0/0, keep in mind that Fa0/1 is not running any NAT.

3 REPLIES

Re: NAT

Hi

Just configure a access-list which should match the address to whom u want to grant access through nat and leave the rest.

And i think u need not worry about this becoz u havent specifed nat inside under f0/1.

Thanks

Mahmood

New Member

Re: NAT

interface FastEthernet0/0

ip address 2.2.2.3 255.255.255.240

interface FastEthernet0/1

ip address 10.10.10.1 255.255.255.0

ip nat inside

interface Serial0/0/0

bandwidth 2000

ip address 1.1.1.202 255.255.255.252

ip nat outside

ip route 0.0.0.0 0.0.0.0 1.1.1.201

ip nat inside source list 100 interface Serial0/0/0 overload

access-list 100 permit ip 10.10.10.0 0.0.0.255 any

Above is my configuration, If i access anything on 2.2.2.0 network coming from serial, it wont route packet at all and I cant get any connection. Any idea how to normally route packets over interface configured with IP NAT OUTSIDE.

Re: NAT

Hi,

The config u have pasted shows that u have match the address from the f0/1 range,in u r first post u mentioned that f0/1 is not having nat inside can u plx confrim.

U have specifed a default route which is pointing to ur ISP i assume. and u r overloading on interface s0/0/0.

i didnt get what u mean by u r statement

Above is my configuration, If i access anything on 2.2.2.0 network coming from serial, it wont route packet at all and I cant get any connection. Any idea how to normally route packets over interface configured with IP NAT OUTSIDE.

can u plz eloborate.

Thanks

Mahmood

106
Views
0
Helpful
3
Replies