Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

native and hybrid modes

whcih command is used to see the native, hybrid modes on layer 3 switch

  • LAN Switching and Routing
1 REPLY

Re: native and hybrid modes

hi aksher,

here you can see the hybrid or native mode...

Console> (enable)dir slot0:

i think there is no any command that show that in proper mode but you have to identify from image name...

here you will get the image name of the IOS and from that you have to identify that switch is runing in hybrid or native mode...

for more detail this link of conversion hybrid to natvie mode will help you to find out the same thing...

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008070f124.shtml

hope this will help you

rate this post if it helps

regards

Devang

113
Views
0
Helpful
1
Replies
This widget could not be displayed.