There is no relation between the management VLAN and the Native VLAN, a Native VLAN is a concept in trunking. The native VLAN is the VLAN to which a port returns when it is not trunking (simply if a PC is connected to a trunk port, the PC will operate in the Native VLAN - by default 1). Also, the native VLAN is the untagged VLAN on an IEEE 802.1Q trunk. Make sure the native VLAN for an 802.1Q trunk is the same on both ends of the trunk link. If the VLAN on one end of the trunk is different from the VLAN on the other end, spanning tree loops might result.
I am not aware of th 1242 AP (but i found the same constrain that you specified, may be its better for you to post this question in the wireless forum), but for normal switched networks, there is no relation between Native VLAN and Management VLAN, and as Arivudainambi pointed out the management VLAN can be any VLAN, and as a best practice we can use a dedicated management VLAN.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...