Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NATIVE VLAN on 4006 (CAT Switch)

HI,

How can we define Native VLAN on 4006 (CAT OS) switches ?

Thanks in advance

4 REPLIES

Re: NATIVE VLAN on 4006 (CAT Switch)

Hi,

Native VLAN is there by default, and it is VLAN number 1 by default and can't be deleted.

HTH, please rate if it does help,

Mohammed Mahmoud.

Purple

Re: NATIVE VLAN on 4006 (CAT Switch)

The native vlan is whatever vlan you assign a port and to which it will return if it is not in a trunked state . To set a port for a particular vlan use the " set vlan X slot/port" command .

Re: NATIVE VLAN on 4006 (CAT Switch)

Hi,

To make the answer complete without misunderstanding, i meant that it is VLAN1 by default, and it can be changed per Trunk interface.

The native VLAN packets are sent untagged on the trunk link. Therefore, the native VLAN should be the same on both switches configured for trunking.

In CatOS, the native VLAN can be changed by issuing the "set vlan vlan-id mod/port" command, where mod/port is the trunk port.

http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09186a0080094784.shtml

HTH, please rate if it does helps,

Mohammed Mahmoud.

Bronze

Re: NATIVE VLAN on 4006 (CAT Switch)

Hi

native vlan mean default traffic , in every switch vlan 1 is native vlan.

-i hope this will clear your doubts

-minu

243
Views
10
Helpful
4
Replies