At the moment my native vlan on both ends of the trunk port to the access point is 2 as its address is 10.100.2.2, which I would like to change to something else (999 per recommended settings). However, I understand that the BVI1 interface on this trunk needs to be on the subnet of the vlan address. Given that, what is the best way to set this up?
I am not entirely sure what your setup is. If you are changing the native vlan of the trunk(s) to 999 then all you have to do is to create a vlan int aka SVI for 999 in the layer 3 switch (gateway) and assign the IP that's currently being used on vlan 2. You would have BVI interface if you are doing IRB. If you are in fact using BVIs then can you post a sanitized copy of you config.
IRB stands for Integrated Routing and Bridging. IRB is used to route/bridge traffic received through the same interface.
You should be able to change the native vlan from to 2 to 999 with the command 'switchport trunk native vlan 999' under the trunk ports on all your switches. On the switch/router that's the default gateway for vlan 2 create a interface for 999 and assign the current vlan 2 IP to it to route traffic for vlan 999.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.