Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

natting to resolve routing issues

Hi all, if I have 2 seperate sites both on a class A 10.x.x.x address, If I nat one one these across on the router to another address range, how would i go about routing between them cause one side would still have a route from a 10 network to another 10 network, is this correct ?

6 REPLIES
New Member

Re: natting to resolve routing issues

can anyone help ?

cheers

Carl ?

New Member

Re: natting to resolve routing issues

Well if you have 10.0.0.0/24 on on side and 10.0.0.0/24 on the other side. You nat a one to one or a natpool to example 172.0.0.0/24 the you would have a route to 172.0.0.0/24

btw please rate if you find it usefull

New Member

Re: natting to resolve routing issues

Hi, I know what you mean, but wont the side which is natted still need a route to the other 10.x.x.x network, I know the source address will be changed but it still needs to go from a 10.x.x.x to a 10.x.x.x one one side, if you understand ?

New Member

Re: natting to resolve routing issues

Well you actually have to setup two networks for that 172.0.0.0/24 is nated to first 10.0.0.0/24

172.1.0.0.0/24 is nated to second 10.0.0.0/24

So two networks to NAT between the 2 overlapping networks.

New Member

Re: natting to resolve routing issues

Ahh I see, so is this always the case for overlaps then ?

New Member

Re: natting to resolve routing issues

Yes. That is the only what I know about that works good.

122
Views
0
Helpful
6
Replies