Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

NBAR Load-Interval

Hi, How can I to monitor a router interface (with NBAR) during more than 600 second?. I would like discovery what application is using more BW In the traffic peak time . TKS

1 REPLY
Hall of Fame Super Bronze

Re: NBAR Load-Interval

The value is associated to the load-interval from the monitored interface.

The maximum value allowed is 600 seconds.

Default setting:

Rack1R1#sh ip nbar protocol-discovery | i Bit Rate

5min Bit Rate (bps) 5min Bit Rate (bps)

5min Max Bit Rate (bps) 5min Max Bit Rate (bps)

Change the load-interval to 30 seconds.

Rack1R1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Rack1R1(config)#int f0/0

Rack1R1(config-if)#load-inter 30

Rack1R1(config-if)#do sh ip nbar protocol-discovery | i Bit Rate

30sec Bit Rate (bps) 30sec Bit Rate (bps)

30sec Max Bit Rate (bps) 30sec Max Bit Rate (bps)

See the available values:

Rack1R1(config-if)#load-inter ?

<30-600> Load interval delay in seconds

If you want to have statistical information, I recommend configuring NetFlow.

HTH,

__

Edison.

328
Views
0
Helpful
1
Replies