Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

need a pbr expert

trying to convert a rather extensive policy from a router to a cat 3750. One problem is that cat does not support route-map delete but after looking at the doci if I understand it correctly that route-map delete is a way to fall out of the route-maps to fall into regular routing. If this is the case, can I do the same thing with a route-map permit but have no set commands?

thx again.

1 REPLY
Cisco Employee

Re: need a pbr expert

Hello,

Yes, you can create a default route-map rule that catches all packets that

do not match specific rules. Then it will go via the regular routing

process. When you are using 3750, please make sure that you are running at

least IPServices image with your SDM template set to routing.

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/1

2.2_35_se/configuration/guide/swiprout.html#wp1228588

Hope this helps.

Regards,

NT

146
Views
0
Helpful
1
Replies
CreatePlease to create content