I met a friend a few days ago who is leasing space in a few buildings. The space came with Cisco equipment and is currently in use. I drew a diagram in Visio the best I could and was looking for advice regarding this current topology. He has two ISP's but is currently using only one. There are two extra 2621xm's and 6 WS-C3508G-XL. I was thinking of using one of the extra 2621xm's and doing HSRP between the 2911. If you take a look at the diagram there are a bunch of WS-C3550-48 switches hanging off the C2970G switch. Unfortunately there are no layer 3 switches. How would you layout this particular diagram given the two extra 2621xm's and six WS-C3508G-XL?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...