Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need Advice

I met a friend a few days ago who is leasing space in a few buildings. The space came with Cisco equipment and is currently in use. I drew a diagram in Visio the best I could and was looking for advice regarding this current topology. He has two ISP's but is currently using only one. There are two extra 2621xm's and 6 WS-C3508G-XL. I was thinking of using one of the extra 2621xm's and doing HSRP between the 2911. If you take a look at the diagram there are a bunch of WS-C3550-48 switches hanging off the C2970G switch. Unfortunately there are no layer 3 switches. How would you layout this particular diagram given the two extra 2621xm's and six WS-C3508G-XL?

1 REPLY
VIP Super Bronze

Need Advice

Looking at your diagram, you can keep all the switches as layer-2 only and have 2 routers (one 2911 and one 2621xm) as the default gateway for all host and run HSRP between the 2 routers.

HTH

93
Views
0
Helpful
1
Replies