Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need assistance enabling portfast on new blade on 4006 switch

We are looking to replace the blade on our switch - upgrading it ot a 10/100/100 from a 10/100 -

In checking the existing config -  it does not look like portfast is enabled on the the card 6 -

What do we need to do to not impact the rest of the switch?

Are there any how-to docs?

Please adivse.

Thanks.

-John

4 REPLIES
VIP Super Bronze

Re: Need assistance enabling portfast on new blade on 4006 switc

Hi John,

Enabling portfast should not impact anything.  Use the interface range command to enable it for all 24 or 48 ports.

HTH

Reza

New Member

Re: Need assistance enabling portfast on new blade on 4006 switc

Than you - where can I find the command?

config t

int range g6/1-48

what is next?

Thanks.,

VIP Super Bronze

Re: Need assistance enabling portfast on new blade on 4006 switc

spanning-tree portfast

New Member

Re: Need assistance enabling portfast on new blade on 4006 switc

Thank you - it worked!

config t

int range 6/1-48

spanning-tree portfast

-John

233
Views
5
Helpful
4
Replies
CreatePlease login to create content