Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Need Commands 2 Tshoot OQD on PO on 3 Stacked 3750E

We walked all interfaces on the LAN. We have high OQD on 8 Gb/s PO to include OQD on the physical interfaces spread across 3 3750 E stacked switches. The througput is only ~2Gb/s and there isn't ever more than two servers on one ASIC. These switches are wired copper to two stacked 3110 inside an IBM blade center. The blade center has an Abnormal Temp Detected error on a DIMM but I don't believe this to be the source of the problem as there aren't any IQDs on the blade center switch stack. I need commands to view parameters on the 3750E stack. Anybody have some good commands to look into this deeper than sh po# int, or sh platform? I have by the end of the day or the new servers are migrated off the switch.

Thanks!
Matt

612
Views
0
Helpful
0
Replies