I am new to networking and am trying to solve this.
I recently created a VLAN on my SRW2024P. It promptly disconnected me from Webview IP, (Which was in fact 192.168.16.254 for this set up).
Now I cant gain access to the switch.
I reset the switch with power off - no access.
I have tried Hypterm with a com cable (I have a com port on my Toughbook). This is not a console cable...Does it need to be?
With the correct setting on COM 1, I can see the POST and Boot (which all pass). However, when it displays "Press Enter to for Main Menu", thats as far as it goes. Enter does nothing. I cannot get a login screen.
I have tried Power on off several times. I have no 45s in the switch. It is clean.
IS this a cable or port issue....Any help much appreciated.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...