Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need help in configuring NAT on this Friday Afternoon...

ok, my brain is no longuer functioning right...

Need to nat an external IP to an internal IP (or port forward of somekind).

Example:

External IP on E1/1 68.10.10.10 port 25

to

Internal IP on F0/1 10.10.10.15 port 25

How could I do this?

This is on a 3600 router, I know it's not a firewall but can this still be done? if so, How?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Need help in configuring NAT on this Friday Afternoon...

You must also enable NAT to happen on the interfaces that it passes through as well.

like; ip nat inside (allow inbound NAT)

Here is an example..

http://www.cisco.com/en/US/docs/ios/ipaddr/command/reference/iad_nat.html

Please rate if it helps...

--Mike

4 REPLIES

Re: Need help in configuring NAT on this Friday Afternoon...

ip nat inside source static tcp 192.168.0.1 80 interface serial0 80

Hope that helps.

New Member

Re: Need help in configuring NAT on this Friday Afternoon...

so this would work for inbound traffic comming from the outside being routed to the internal device?

Re: Need help in configuring NAT on this Friday Afternoon...

Yes assuming that other NAT configuration is in place.

New Member

Re: Need help in configuring NAT on this Friday Afternoon...

You must also enable NAT to happen on the interfaces that it passes through as well.

like; ip nat inside (allow inbound NAT)

Here is an example..

http://www.cisco.com/en/US/docs/ios/ipaddr/command/reference/iad_nat.html

Please rate if it helps...

--Mike

92
Views
0
Helpful
4
Replies