Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Need Help in LAN Configuration

Good day networking gurus!

I was designing a Network using Packet Tracer 4.0. Unfortunately, I came across a dead-end. I cannot think of a way to let two Routers communicate.

Here is the format.

Executive Computer

|

Executive Router

/ \

Managerial Router A Managerial RouterB

| |

Managerial Computer Managerial Computer

--

I am pursuing this angle because when I tried putting a switch between the Managerial Routers and the Executive Routers but to no avail.

Subnet: 255.255.240.0

IPs:

Executive Comp - 143.99.16.2

Executive Router 0/0 - 143.99.16.1

0/2 - 143.99.32.1

Managerial Router A 0/0 - 143.99.32.2

0/1 - 143.99.48.1

Managerial Computer A - 143.99.48.2

I have not yet setup Mangerial B. MC A does not ping the Executive Router.

Thanks in advanced.

Erwin Merioles

1 REPLY
Cisco Employee

Re: Need Help in LAN Configuration

Hi Erwin,

I suggest you get some outputs , may be just a "sh run" from the 2 routers.

I hope you have already checked the configs from ground-0 level.

Regards

Rajat Chauhan

100
Views
0
Helpful
1
Replies