Some of the things you want to look at, from just a quick peak, is the connection types. Make sure you have the right types of connections to the devices. Others include IP addressing and the EIGRP and the area ID's.
Again please take what I stated before. Also just looking at the first router IP addressing, you need to make sure all addressing is correct. I can see from the first router there are a couple of IP addresses that are wrong. When you are working on these start where you might be able to ping and go from there.
Ping from fa0/0 to the access device. If that does not work then make sure the cable is correct and the IP addressing is correct. If it can ping then you should be OK done with that. Ping fa0/1 if it fails again check IP and cable.
I would make sure all devices can ping their neighbors before you look at routing. After all can ping their neighbors then take a look at the routing and routing protocols. Look at the EIGRP ID's make sure they are correct.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.